ABS021/27 – 27mm – CAPILLARY END CAP

ABS021/27 – 27mm – CAPILLARY END CAP

The capillary end cap is used when it is necessary to sample air not only in the pipe run, but also at the end of the pipe run. It fits directly onto the end of the 27mm pipe. There is a 10mm hole in the end cap, which attaches normally to a 10mm OD nylon tube of a pre-determined length to which it is possible to attach either a discrete flush or a conical sampling head.

Beschreibung

Installation Instructions:

Use the correct solvent Plusbond 3019. Do not paint. Keep pipe clean and free from dust. Do not install in direct sunlight. Only install with approved pipe. Do not use solvents to clean, only soapy water.


Pipe Colour: RED
Diameter Tolerance: +/- 0.15mm

Go to Top